Before installation
- Have the connection made by a qualified electrician, following the electrical rules of your country.
- The circuit must be protected by a 30 mA residual current device.
- Luz mirrors are rated IP44: protected against water splashes from all directions. Install them only in the bathroom zones where local regulations allow this level of protection.
- Choose the position: usually centred above the basin, at a height that suits the users.
Installation, step by step
- Switch off the power at the consumer unit.
- Mark the fixing positions, level.
- Check for cables and pipes, then drill using wall plugs suited to the wall.
- Have the electrician connect the mirror according to the wiring diagram supplied.
- Hang the mirror and check that it is secure and level.
- Switch the power back on and test the touch switch, the anti-fog function and the three light temperatures (3000 K, 4500 K and 6500 K).
Everyday care
- Switch the light off and wait until the glass is cool.
- Dampen a microfibre cloth with water or a mild glass cleaner. Spray onto the cloth, never directly onto the mirror.
- Wipe from top to bottom, then dry straight away with a second dry cloth.
- Keep the edges and the touch switch area dry.
- Ventilate the bathroom during and after showers.
The 5 mm copper-free mirror limits black spots and darkened edges. Drying the edges well remains the best care.
What to avoid
- Ammonia-based cleaners, bleach, acetone and solvents.
- Abrasive pads, steel wool and scrapers.
- Water running onto the edges or behind the mirror.
- Any work on the electrical parts: if there is a problem, contact your retailer.
A non-compliant connection or work on the electronics is not covered by the warranty.